Stud.io joining sub-models

[knotian]

I have a large model made up of sub-models, with distinctive pins joining them together.

Is there a way to show the pins partially inserted on one page of instructions, then on the next page show them inserted, with arrows.

It seems like I can't isolate the 'pin pushing ' as a page in instruction builder. They only show in their final position.

I could leave the pins out of the submodels and then insert them in a separate step, but I'd like to do the two step way like TLG instructions.

Edited May 16, 2019 by knotian

[supertruper1988]

Place an empty step after then use the buffer exchange to move them.

[knotian]

I'll give it a try on the next project. Already went for the pins as a separate step route.

Thanx,

Ed

Edited May 22, 2019 by knotian