DarthTrocious

Here’s hoping for a Ree-Yees, Bossk, Gamorrean Guard and Yak Face battle pack.

Agreed. I thought maybe Zal Dinnes or Torge Grommer, but alas…

Does anyone have any idea which (if any) rebel pilot helmet iconography that is?

I haven’t seen any depictions of the T-65 X-Wing in 1:1455 scale so I thought I’d throw my solution out there. https://rebrickable.com/mocs/MOC-182540/MTgreg/t-65-x-wing-starfighter-in-nano-scale/#details Suggestions/alternative solutions welcome.

I was just going to reply, if you’re patient I’m sure a much better Outrider MOC is just around the corner. Unfortunately I parted this out years ago, and built it mostly with pieces I had on hand. If someone is committed to a MOC in the same line as this one I’d recommend buying a system scale Millennium Falcon and building the Outrider off of the saucer and frame.

Or four half bushings stacked. Those little ones have clutch power. I’m sure with enough inertia one could remove it. I imagine a bullet puller impact hammer modified with a slot for the 64179 7x5 technic frame would remove the axle without having to pry it out with a knife.

Isn’t this a similar situation to the Technic Axles w/ Stop that are inserted to attach the wings on 10212 Imperial Shuttle? Step 38 in Book 3 of the instructions; https://www.lego.com/cdn/product-assets/product.bi.core.pdf/4597963.pdf

297 pieces according to Bricklink Special Assembly page: https://www.bricklink.com/v2/catalog/catalogitem.page?P=spa0022#T=C&C=0 That total includes no figures.

“Yeah. I got a question. Does Barry Manilow know you raid his wardrobe?”

In case anyone was wondering, this is what it looks like with the new pieces 2X 29119 and 2X 29120 in white replacing the 2X 11477 at the nose. https://m.imgur.com/a/JRUUHHY

Nicely done. No Orrimaarko, aka Prune Face?

Unfortunately I don’t use or have access to LDD. I’d recommend starting with the instructions to 7965, then modifying as the build progresses. Incidentally I’ve made a few modifications since the OP. No more angle in the oblique arm where it meets the saucer and medium blue (?) has been replaced with sand blue. https://flic.kr/p/RSVcqW https://flic.kr/p/RSVcq5

Thanks all. LEDs would look nice, but I have zero experience. I’d like to “inverted tile” the entire bottom, but that would likely be an expensive order. Maybe incrementally over time. The cockpit was a headache. Very difficult to render in LEGO. It’s probably considered sacrilege but I’ve always preferred this ship over the Falcon.

Here is my rendition of a YT-2400 light freighter. It was built based on Google Images search results, Sato's Hammer from Rebels and memory. I would suggest that it is somewhere between "System Scale" and "Minifig Scale" (Ostensibly Scaled?). My self-imposed requirement was the "saucer chassis" of 7965 and 4x4 Heat Exhaust Vents for a baseline. I built carte blanche from there. It is very solid, sturdy and heavier than it looks. It can be lifted with one hand from most points (except the cockpit and of course the "pie slice" roof panel sections). I am thinking that it is around 3,200 pieces. It is 20 inches (51 cm) wide, 12.5 inches (32 cm) long and 7.25 inches (18.5 cm) tall. I hope the pictures show up and are the right size. I haven't uploaded images before. Comments, criticisms and suggestions are welcome. Thank you.

60208