Wintermoog

Hey Fuppylodders that's brilliant - thanks for building it! Sorry if the instructions weren't clear or if I got them wrong. If you shift your back panel DOWN by one stud - so that the bottom edge is then half a stud below the side panels then everything should line up. The 4 blue technic pins at the back of the bottom white technic frame will connect with the 2nd and 4th holes in the centre of the 2x6 plates. Hope that helps. And you are so right about the two yellow technic pegs connecting the head beam - was a nightmare for me too!

Hi. They are 2x2 round plates with a hollow stud in the center: https://www.bricklink.com/v2/catalog/catalogitem.page?P=18674#T=C But you could probably use a regular 2x2 round late (with 4 studs) or a 1x1 round plate (with a hollow stud). The 4 bits for the eyes are taken straight from the UCS Porg. Good luck!

Hi. First post here. If you have the 75255 Yoda set, here is a Baby Yoda you can make from it. The only (tiny) cheat is in the eyes as there was nothing in Yoda that would work, so I had to pull the pupils from 75230 Porg. It's only 4 bricks so I hope you can forgive that, and they are standard bricks so finding alternatives should be easy if you don't have Porg.. Free instructions are at https://rebrickable.com/mocs/MOC-37688/Wintermoog/baby-yoda Baby Yoda by Wintermoog, on Flickr Thanks for looking.

Hi. First practise post. Just checking that I can embed a flickr photo and a link. Here goes: Baby Yoda by Wintermoog, on Flickr https://rebrickable.com/mocs/MOC-37688/Wintermoog/baby-yoda