Daan1234

If you look closely at the gear indicator (you have to remove fairing to see it properly), you will observe that it can only get stuck between 2nd and 3rd gear. See photo below. For some reason, they placed the gear indicator dangerously close to some part of the frame. There is an extremely small margin between both black parts, and sometimes I can see them touching. This only happens between 2nd and 3rd.

Maybe the red gear indicator at the right side of the bike (though hidden by body panels) is getting stuck behind part of the frame. This only happens between 2nd and 3rd gear.

You are probably right. I am almost finished (bike is on its wheels). It looks beautiful already. Everything runs smooth when I ride the thing across the table, in all gears. When I put it on the black stand and press on the tank and turn the rear wheel it runs rough. I guess you aren't meant to play with it when it is on the center stand, which makes some sense. Can you guys try rotating the wheel while pressing lightly on the tank area whilst the bike is on the stand? I'm curious if you experience the same.

Those who have built this set, do you experience any problems with the transmission? I find mine is very susceptible to deformation. I am in the process of building right now. When I push the red beam which is located on the gear selector axis with the blue drums, the transmissions runs noticeably rough. Sometimes even to the point it completely locks up. After I put the engine/trans module into the frame, I find just lightly pressing on the gas tank area makes the transmission run very rough to the point I break the chain by just pulling it. Mechanically it works fine though. Either I made a mistake during building or the trans is just not stiff enough at all.