Cyclotron102

Hello, So these buttons not for switch on or off the outputs Seems not working perfect Than you

Hello I can not find how to invert the output of the Sbrick, android

The android app not perfect, but it works. I have tested the M L XL and servo. Thank you Sbrick team, well done!

I got mine today :D

If I turn the cylinders 90 degrees, then the upper connection point were impossible, or very strange. I lowered the switches one stud, now better, but I can't because the tubing. At the weekend I will try these at the real model and will see.

The room for the tubing between the top inlet and the grill could be tight

It is possible, but i can't put closer the cylinders to the grille, because of the tubing. Or I can increase the distance between the big cylinders, but then i have to think about where can I put the tubing, now it is guided under the structure I will make few solutions Possible, but the tubing are very tight at the switches already

Helo, the model in Ldraw more or less is finishd. Right now I'm making the tubing for the pneumatics. LSynth need a lot of patient :)

same in Hungary I think it will be an update

the small one can be hidden in the base, and you can operate with the exhaust pipe or the air filter for the bigger one i have some idea, i want to be it invisible

it will be manual with 20:12 gear ratio, but if the performance will be not so good, i change it to the big manual pump

Hello, I like Efferman's Cat D11 so I'm going to make it pneumatic i modified the inside, remove the gearing, there will be a small pneumatic pump at the moment I'm here:

Congrats superb!

Backed

I think it could work good with this http://www.eurobricks.com/forum/index.php?showtopic=91329 because in real life these giants working with the same principle