THIS IS THE TEST SITE OF EUROBRICKS!
Search the Community
Showing results for tags 'Third Party Tires'.
Found 1 result
-
Now not to be confused with this thread here (Third Party Tires for Lego Technic Rims by Efferman), This Thread is Different in the Sense that I developed LEGO Modification instead of just wheel swapping. Now it is RC Tires Mods for Lego Technic Axles. Here below is a Rubber RC Tire. The Wheel does not fit over Lego Axles to begin with. Its hard to tell from picture but trust me the hole on the RC wheel is too small to fit around the LEGO Axle. And that is where the First Modification begins. In this picture Below is the aftermath of the first Wheel Modification. Now because I live in U.S and measurements are defined in standard I'm using a 3/16 drill bit to make this hole which is 4.7 mm for those who know metric.I used a Drill Press for a center and aligned hole for it. Just take Note that the Drilled Hole is little smaller from the patented LEGO Technic Hole so the Lego Axle will have nice tight fit with it naturally if you use a Standard drill bit to do this. Now Once the hole was drilled my next step was attaching it to LEGO Axle Bushing. This is where the Challenge is because I needed to somehow fix this Axle Bushing inline with the Hole. Now I made this LEGO Wheel Stand here to fix the Lego Bushing inline with the RC Tire. I placed the busing on top of the Axle to show you what it looks like with out the tire. With the Tire sitting level on the Lego Part, I used Super Glue for a quick bond between the LEGO Bushing and the RC tire. Now the Super glue is just there to make a nice initial bond. The real Holding bond will be done with JB weld filling in the 12mm Hexnut wheel mount. Take note that the Pictures Below are with out the Lego Bushing and only relying upon the natural hold between the tire and the axle. I took these pictures because there will be plenty of pictures when the RC Lego Tire Mod is finished.
