THIS IS THE TEST SITE OF EUROBRICKS!
Search the Community
Showing results for tags 'beam'.
Found 2 results
-
While learning LDD, I am facing a problem. I used Hinge Align Tool to fit a Bean with my model which I added successfully. But it resulted a slight tilt to my whole model with ground, which I do not want. So now one end of model is on ground where other is a bitrHow can I rotate the whole model to rest it completely on ground?
-
Hi I am working on gear pairs meshed directly together, in a 2 by 2 arrangement. Two gears on each of the two axles - However one gear is an idler gear which is driven by the other gears instead of with the same rotation speed as the motor. However I'm not sure if the ratio for the idler gear will be 1:1 since there is two 16 tooth gear gears in either example I don't think it is 1:1 though it should be what the other two gears are, so say 3:1 or 1.6:1 but I'm unsure as it's hard to tell. The yellow axle joiner goes to the motor, I'm using a differential to replicate a single 24 tooth idler in the first image. Obviously the dark grey gears are the idlers. Any ideas what it could be. More gears can be used with studed beams and plates such as 16 tooth +12 tooth or 20 + 20 or 16 + 20 etc. Regards, S
