THIS IS THE TEST SITE OF EUROBRICKS!
Search the Community
Showing results for tags 'gearing'.
Found 4 results
-
I would like to know if anyone of you found any compact replacement assembly of pair of bevel gears in setup shown below? I want to build alternative model out of set 42036 (motorbike) that doesn't contain any bevel or crown gear but I need to turn driven axle by 90 degrees. Do you have any idea how to do it only with parts from set 42036? Thanks -
On rebrickable. Thanks to 1963Maniac for creating these instructions - a lot of hard work much appreciated. https://rebrickable.com/mocs/MOC-42806/TechnicBrickPower/billion-to-one-gearing-tower The video about it: -
Hi! I built a telescopic tracked car, that can extend in two directions to overcome obstacles ? Have a look and subscribe to my channel, if you want more videos like that (building instructions available). Thanks! -
Hi All! Often a "reader", now a "poster", i´ve got a problem i cant fully wrap my head around. I try to keep a steering axle straight while going through a pivoting point or turntable. The axle should rotate with the pivot (eg in the picture below the yellow bricks should always align with the grey liftarms even if the liftarms are at 90 degrees of each other) but i want to rotate it manually on one side, with the rotation + offset of the pivot on the other side. Like the axle itself would have been twisted. The furthest ive got with this is pictured below and works as long there is no friction on the left output. I want both sides to rotate at the same time, but if you rotate the pivot/turntable then it should add just an offset "within" the axle. I dont know if this is actually possible or how to split the axle in two, add the pivot rotation to one part and then add both rotation together.
