Where is that lbg 4pin with middle axle hole used???

Edited November 27, 201410 yr by MajklSpajkl

Where is that lbg 4pin with middle axle hole used???

Between the 3x5 liftarms, by the pullback http://www.eurobricks.com/forum/index.php?showtopic=99511&st=700#entry2064394

Where is that lbg 4pin with middle axle hole used???

To connect the 2 3x5 L-beams that hold the PB motor

Yes, I see it, i used black double pin connector with a hole in the middle :-(

Now seriously guys the second cylinder would be visible here but it isn't.. Tried ldd from the same angle and it's supposed to be visible

@Shimon: I agree, but those photos are heavily altered by photo editing software and that one v cylinder might have fallen out while editing... If that cylinder is all you're missing you should do fine :-) I alao think, that it is not possible to reproduce all the angkes of real photos in LDD, perspective is different.

@Shimon: I agree, but those photos are heavily altered by photo editing software and that one v cylinder might have fallen out while editing... If that cylinder is all you're missing you should do fine :-) I alao think, that it is not possible to reproduce all the angkes of real photos in LDD, perspective is different.

i think it would be fair if the second cylinder wouldnt count because of that picture..

its not my only problem unfortunately,

the sad part is that for the two pin axle hole connector+ the dbg 2l pin 1l axle hole being put from right to left instead left to right i get -6

anyway i counted 48 mismatches and without the cylinder\pin direction problem 37

i bet the technic pros here did way better so better luck next year

I think there should be no "discounts" - many could also ask that for the invisible parts, but there is no point in the whole challenge then...

I saw the second cylinder from the picture below. It is the only one where it is barely visible... now to see how many mistakes I did

Still if a picture shows a blank space and there's a part there it's not normal and should be considered.

I think there should be no "discounts" - many could also ask that for the invisible parts, but there is no point in the whole challenge then...

True. Yes that one picture is altered and the cylinder not visible, even though LDD shows it, but the rules are there to not leave any room for interpretation. Still, the challenge was pretty darn challenging and fun to do. Don't you think?

There are building instructions for quad bike already available on lego.com:

http://cache.lego.com/bigdownloads/buildinginstructions/6124828.pdf

I apologise to bump this old topic, but what's happened to this Techreverse 2014 in the end? It just occured to me that I don't recall it being finished at all. I still have my self-controlling list of flaws, but I don't remember Conchas announcing any results on this?

Thanks for info and sorrry again for bringing this up.

Best regards, miha

I think it wasn't finished. I haven't got any request for list of flaws from Conchas either. We might ask him what has happened.

I'll send him a message via PM...

You're absolutely right! :(

I need to end this process as soon as my personal affairs allow me move forward with this topic.

Unfortunately it has been in the to do list and bugging me for too long. :(

It took me also too long to manage to get the prizes this time, but anyway they already arrived for more than 1 month.

No problem, thx for info. You'll manage when you will, I guess we all understand...