hello everyone,

i have a problem on 8110's front bridge.

It seems a bit excursion, and i havn't found where i was wrong.

i try to backout the black joint lever, it will be OK.

help~~~

Edited November 18, 201410 yr by flashtom

A bit difficult to understand what the issue is ... can you elaborate a little more?

  On 11/18/2014 at 2:57 PM, DrJB said:

A bit difficult to understand what the issue is ... can you elaborate a little more?

First of all thank you.

8110's front bridge was deflection to right.

Not in center.

I don't know why.

The process was all follow by user guide step by step.

ok, probably I have the answer. The front "bridge" it's hold by a pin and an arm bush. Make sure the pin it's in the right hole...cos there are 2 holes close to each others.....if you put it the wrong one it will skid the all axle.

hello flashtom

not exactly sure why its not centered. im going to take a guess that your shocks have not been put on both the same way. check in book two were the shocks attach to the front of the chassis page 71 step 97. hope this helps, it may help with a few more pics

doug

Are you talking about the front axle being a little to the right side when the suspension is not compressed? If so, that is the way it is intended to be. The reason is to make the front axle stay in the center when the suspension is compressed.

  On 11/18/2014 at 3:19 PM, TheItalianBrick said:

ok, probably I have the answer. The front "bridge" it's hold by a pin and an arm bush. Make sure the pin it's in the right hole...cos there are 2 holes close to each others.....if you put it the wrong one it will skid the all axle.

Thank you.

That pin is in correct hole.

  On 11/18/2014 at 3:31 PM, dougstar said:

hello flashtom

not exactly sure why its not centered. im going to take a guess that your shocks have not been put on both the same way. check in book two were the shocks attach to the front of the chassis page 71 step 97. hope this helps, it may help with a few more pics

doug

Thank you dear.

:D

ITS NORMAL Pahnrod is at an angle and it slightly pulls the axle sideways.

Hi, here is the solution to make the axle be in the most center place:

http://www.brickshelf.com/gallery/imanolB/unimog/p1120669.jpg

(used in the rear axle):

http://www.brickshelf.com/gallery/imanolB/unimog/p1120672.jpg

and the proof:

http://www.brickshelf.com/gallery/imanolB/unimog/p1120676.jpg

http://www.brickshelf.com/gallery/imanolB/unimog/p1120677.jpg

hope this works for you.

Edited August 4, 20159 yr by Blakbird
: removed massively oversized images.

please don't bump

maybe you should repost this in the 8110 mods topic

good idea though

TNLD

Edited August 4, 20159 yr by TheNextLegoDesinger

ok, i have just post it on Unimog 8110 mods and improvements, should i delete my previous post?