Jump to content
THIS IS THE TEST SITE OF EUROBRICKS!
THIS IS THE TEST SITE OF EUROBRICKS!

Featured Replies

Posted

Hello, I have been recently wondering "How can I make fast air with my pneumatic pumps"

I have built a fully functioning, belt driven system which turns the pump at a hell of a speed already, it can go even faster by adding a smaller pulley, but I didn't incase the pump got caught up and snapped. I was filling my air tank up with it, the pressure got so good the pipe popped off the air tank, it filled within 3 seconds, with a small grey pump. I have produced this setup out of a powerful RC motor and meccano and a thick belt and 2 pulleys. I had drilled a hole into a flat circul and attached it to a shaft as an offset gear which drives the pump. If anyones interested, I will take a picture.

Hello. It is nice to hear that you have made very efficient pump, but modifing LEGO pieces is not something that I like. Also, it is good to post some pictures when you want to show us something.
Also, welcome to Eurobricks :)

  • Author
  On 12/4/2016 at 8:07 PM, M_longer said:

Hello. It is nice to hear that you have made very efficient pump, but modifing LEGO pieces is not something that I like. Also, it is good to post some pictures when you want to show us something.
Also, welcome to Eurobricks :)

Who said anything about modifying Lego pieces?, I have not touched the lego pump in anyway, my Meccano piece is the part I modified to work with the pump, pump Is untouched

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

Recently Browsing 0

  • No registered users viewing this page.
Sponsored Links