[MOC] Ram 1500

[BrickbyBrickTechnic]

A heck of a pickup truck!

 

It's RC! There ae several functions:

-Suspension (positive caster on front, live axle on rear)

-Opening doors and hood

-8-speed gearbox

-Drive and steering

That's it! Thanks!

BrickbyBrickTechnic

[Jurss]

I like the overall looks, but ... :)

Lot of 3L pins used, but not full lenght, so part of them in lot of places popping out. I just don't like it. Yes, whem building, I have them also, but then I clean up, un put 2l pins where needed.

Also this gap

And yes, also that reciever. Car ir pretty big, it shoud be possible to place reciever and battery better.

 

 

[BrickbyBrickTechnic]

1 hour ago, LvdH said:

I like the overall looks, but I would change the receiver's location. It looks somewhat messy in the bed.

You are completely right about that, but the wires would have stretched for the 2 XL motors if I had put it in the cabin. I could probably figure that out and put an updated photo.

39 minutes ago, Jurss said:

I like the overall looks, but ... :)

Lot of 3L pins used, but not full lenght, so part of them in lot of places popping out. I just don't like it. Yes, whem building, I have them also, but then I clean up, un put 2l pins where needed.

Also this gap

And yes, also that reciever. Car ir pretty big, it shoud be possible to place reciever and battery better.

 

 

For the pins (and the gaps), could the 1l bushes in DBG change that (If I just put them on the pins)? 

[Jurss]

When I'm building, I'm trying not to leave gaps at all, if it's not planned or needed by design. As it is floor, then I would try to make it closed as possible. Looking at Your other builds, You have done better.