[MOC] Liebherr LTM11200 crane

[blurr95]

On 2/11/2019 at 6:32 PM, nigel1975 said:

Today I finished the boom section, making four MODS

i) made the boom one stud higher so that I could run the axles on the inside and thus close the top of the boom with panels

ii) filled the sides of the boom whilst maintaining the axles for lowering the support legs, this has made the boom much sturdier (and a bit heavier)

iii) changed the design of the end of the boom where the pulleys are connected

iv) modified the stabilizer arms to look more in proportion and allow for stickers

 

I also figured out how to link photos to Flickr :-)

 

IMG_1996 on Flickr

IMG_1991 on Flickr

IMG_1985 on Flickr

IMG_1988 on Flickr

Hi all, sorry to bring up an older thread. I am getting ready to start building this amazing MOC with my son, and we are really looking forward to it. But I have a couple questions for you Nigel1975. Do you have any more pictures of the mods you did to the boom that shows more of what you changed? I can't really see what you did with the arms folded in, How did you make it one stud higher, and how did you move the axles to the inside? Thank you for any help you can give.

Jason

 

On 2/11/2019 at 6:32 PM, nigel1975 said:

 

 

[NummerE1ns]

Hello,

I have bought the instruction from jeroen. @nigel1975, do you have some pictures of building the boom or an instruction? Or some detail pictures of the y arrangement an open side picture to see the side?