Mostly finished up my MOC-0631 build (I'm thinking of additional lighting in the future):

 

I made the subfloor in stud.io.  If you're interested in those files, just message me.

I changed up the fight area panels a little (they're a little more stable with the top being anchored) and ran the wires for the two lights in the corner to power up the lightsabers instead:

Edited August 16, 20195 yr by crimson30

Just some clarification...

I used a kit from brickstuff for most of the lighting.  The exception is that I bought these:

Pre-soldered Micro LEDs (SMD 0603 white) @ Amazon

and these: Cables for the A3 board from Brickstuff

for the sabers.  I borrowed a hand drill to drill through the arm and saber.  Also, there was a problem with light shining through the sabers, so I used black heatshrink to wrap around the inside hole.  Also, I tested it without the resistor and the LEDs burned up; then I tested with the 100 ohm resistor (for each saber) and left it on for about 12 hours without any issues.

Edited August 15, 20195 yr by crimson30

Looks really nice! The lighting is done well!

Very nice work!  This is a build I always wanted to do, but don't have room to put it anywhere.

11 hours ago, Reaper said:

Looks really nice! The lighting is done well!

I really love the chase lighting... here's a video of it:

Bay 327 vid

 

5 hours ago, sandtrooper said:

Very nice work!  This is a build I always wanted to do, but don't have room to put it anywhere.

A friend of mine found a 40" x 40" table for me that fits right in the corner of my basement.

Edited August 16, 20195 yr by crimson30