[Help] Legal technique to insert bar in axle hole?

[stevendejong]

Hi all, a question:

Studio allows inserting a bar (in this case a 4L) into the axle hole pictured, but at the same time, the visuals suggest this doesn't fit. I don't have the 67695 at hand to test this. Does this fit, or not? And the other axle hole?

 

[Lok24]

Yes, this works without any problems.

With any axle holes.

Edited June 24, 2024 by Lok24

[msk6003]

Inserting bar in axle hole is legal. But I don't know about part like that which has some kind of thin wall between 2 axle hole. Like that or axle joiner.

Theoretically it has 3.18mm hole so bar can go through hole. But I don't know it is legal.

Edited June 24, 2024 by msk6003

[Berthil]

I have this specific part in Black and DBG and the bar does NOT go through all the way.

[stevendejong]

2 hours ago, Berthil said:

I have this specific part in Black and DBG and the bar does NOT go through all the way.

Thanks! Does it go halfway through? What about the top axle hole, does the bar go through there?

Thanks everyone so far!

[vascolp]

There are five different versions for this part!

I found three in my collection and:

• 32174: ok, all the way
• 60176: not ok, but it goes half way
• 93571: ok, all the way

Yours seems to be the most recent one.

 

[gyenesvi]

Yes, in general it should be legal, only thing that can prevent you as others said is if a part that has axle hole longer than 1 unit, than those may have a stopper in the middle.

[stevendejong]

Thanks all!