Help needed for creating custom parts in Studio / Part Designer.

[mikey777]

When i draw a brick,plate,tile. it turns into a horrid square.

Anyways. Give me a solution!

[Murdoch17]

@mikey777

If this is in Stud.io, I would suggest asking over on Bricklink's Studio forum, as it's their program and might be a known issue. You'll get a much quicker response on Bricklink as well.

[JopieK]

4 hours ago, Murdoch17 said:

@mikey777

If this is in Stud.io, I would suggest asking over on Bricklink's Studio forum, as it's their program and might be a known issue. You'll get a much quicker response on Bricklink as well.

One can barely see it, but he is in parts designer.

@mikey777 don't go into part designer unless you want to design custom parts, just stay in the main mode...

[mikey777]

6 hours ago, JopieK said:

One can barely see it, but he is in parts designer.

@mikey777 don't go into part designer unless you want to design custom parts, just stay in the main mode...

what main mode?

[JopieK]

Part Designer is a different tool, you should Studio unless you want to make new/custom parts.

[mikey777]

17 hours ago, JopieK said:

Part Designer is a different tool, you should Studio unless you want to make new/custom parts.

i want to make custom parts without the parts being disgusting 2d squares.

[JopieK]

Aha, but that was a little difficult to get from you initial post. Also the topic name does not give any clue of course.