Posted January 29, 201312 yr Hi folks. I'm a new member to please forgive me if I'm in the wrong place... Just wondering if anyone has any advice on pressure testing the lego pneumatic systems. I'm building up some old models, I know I need to replace bits, but want to know which bits without going through hours of swapping them around. Also, what's the best advice for old pneumatic rams that are a bit 'lumpy', is there a safe way of lubricating internal seals? I've thought of a hyperdermic and thin motor oil, but don't want to use anything that's going to damage the plastic or o-rings. Any help gratefully received.
January 29, 201312 yr LEGO makes a pressure gauge that comes with one or two of the LEGO Education pneumatic kits. The kits are expensive, but you may be able to find a gauge on bricklink or ebay. Welcome to the forum! Edited January 29, 201312 yr by dhc6twinotter
January 30, 201312 yr If you simply want to test for leaks i would suggest running an axle through both ends of a cylinder, then one or two sturdy rubber bands around the axles. hook the cylinder up directly to a pump and pump it just enough to fully extend it. If it stays extended then the pump and cylinder are good enough to use. If the rubber bands make the cylinder retract than you have a leak in your pump and/or you cylinder. You can trouble shoot this by replacing the pump or the cylinder, until you find a good combination. Once the pumps and cylinders pass that test you can test the retracting of cylinders using LEGO shock absorbers on the axles. If the cylinders stay still for ten to twenty minutes then they are good enough to use in models. Just be sure to use just enough air pressure to fully extend and retract them, don't keep pumping once they max out. Valves can be tested by simply adding them in-line between the pumps and cylinders and repeating the tests.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.