I'm using the motorcycle head tubes as steering knuckes to get kingpin inclination. Des anybdy know a way to get wheel hubs to be vertical using these? I'm using it in a solid ale, so I don't want any camber.

Use a different brick?

I would, but I'm trying to get the setup as simple as possibe while still having good geometry.

Is it a 22.5 degree angle? if so, you might be able to use a 22.5 degree connector. Otherwise, I'm going to have to agree with Zblj. I'm betting there's a simpler way to do it.

Ok, you're probably right. I'll keep experimenting.

Edited September 1, 201311 yr by Technyk32231